NX Nastran DMAP Programmer's Guide - Kxcad.net

Format 2: (KEY=’USET’):
OPT1 Input-integer-default=0.
Controls the tabular printout of the degree of freedom sets.
Sequence Print USETPRT
None None(default) -1
Row sort only 0
Internal Column sort only 1
Row and column sort 2
Row sort only 10
External Column sort only 11
Row and column sort 12
TABPRT
Formatted table printer
The degrees of freedom can be listed in ascending order according to
their internal or external sequence number, but not both. The external
sequence number is the grid, scalar, or extra point identification
number. The internal sequence number is the number assigned after
resequencing.
For a given sequence there are two types of tables that may be printed:
row sort and column sort. For row sort, a table is printed for each set
selected by USETSEL. Here is an example of row sort (USETPRT = 0
or 10):
U S E T D E F I N I T I O N T A B L E ( I N T E R N A L S E Q U E N C E , R O W S O R T )
A DISPLACEMENT SET
-1- -2- -3- -4- -5- -6- -7- -8- -9- -10-
1= 2-1 2-2
For column sort, a single table is printed for the following sets: SB, SG,
L, A, F, N, G, R, O, S, M, E. Here is an example of column sort
(USETPRT = 1 or 11):
144