NX Nastran DMAP Programmer's Guide - Kxcad.net

718
Name Type and Description
NOSORT1 Integer. SORT1 format flag. Set to -1 if SORT1 format is not requested
for current superelement. Output by SEDR.
NOSORT2 Integer. SORT2 format flag. Set to 1 if SORT2 format is requested.
Output by MDATA, SDR2, and VDR.
NOSORT2S Integer. Solution set SORT2 format flag. Set to 1 if SORT2 format or
x-y plotting is requested for the solution set; -1 otherwise. Output by
VDR.
NOSOUT Integer. Solution set (d- or h-set) output flag. Set to 1 if any solution
set output is requested; -1 otherwise. Output by VDR.
NOSSET Integer. Number of degrees-of-freedom in the s-set. or single point
constraint flag. Set to -1 if there are none. Output by GP4 or
PARAML.
NOSUP Integer. Element summary table request flag.
1 Generate EST only (usually for linear analysis)
2 Form EST, ESTNL and ESTL (usually for nonlinear analysis)
NOTEMP Integer. Thermal load existence flag. Set to -1 if no TEMP or TEMPD
Bulk Data entry images in GEOM3 and ETT is not created, +1
otherwise. Output by GP3.
NOTFL Integer. The number of transfer function Bulk Data entries. Set to -1 if
no sets are defined. Output by DPD.
NOTIME Integer. Time out flag. Set to 1 if there is no time left for further
iterations but enough time to perform data recovery. Output by
NLTRD.
NOTRACK Logical. Mode tracking success flag. Set to TRUE if mode tracking
was successful. Output by MODTRK.
NOTRL Integer. Set to 1 if transient time step parameter Bulk Data entries are
processed, -1 otherwise. 1 also means TRL is created. Output by DPD.
NOUE Integer. The number of extra points. Set to -1 if there are no extra
points. Output by DPD or PARAML.
NOUG Integer. UG presence flag. Set to -1 if UG already exists for the current
superelement. Output by SEDR.
NOUGD Integer. Flag for external input of auxiliary model displacement
matrix. If NOUGD>0, then matrix exists.