NX Nastran DMAP Programmer's Guide - Kxcad.net

SDR1 Computes solution and single-point forces
SDR1
Computes solution and single-point forces
Computes and appends the solution (displacements, velocities, acceleration) and
single-point forces of constraint at the g-set for each boundary condition. Also
appends applied loads.
Format:
SDR1 USET,PG,UL,UOO,YS,GOA,GM,PS,KFS,KSS,QR/
UG,PGT,QG/
NSKIP/APP/NOQG $
Input Data Blocks:
USET Degree-of-freedom set membership table for g-set.
PG Static load matrix applied to the g-set.
UL Displacement matrix in l-set.
UOO Displacement matrix in o-set due to applied loads on the o-set with the
a-set fixed (set to zero).
YS Matrix of enforced displacements or temperatures.
GOA Omitted degree-of-freedom transformation matrix, o-set by a-set.
GM Multipoint constraint transformation matrix, m-set by n-set.
PS Static load matrix partitioned to the s-set.
KFS Stiffness matrix partition (f-set by s-set) from KNN.
KSS Stiffness matrix partition (s-set by s-set) from KNN.
QR Matrix of determinate support forces.
Output Data Blocks:
UG Displacement matrix in the g-set appended for all boundary conditions.
PGT Static load matrix applied to the g-set appended for all boundary
conditions.
QG Single-point constraint forces of constraint matrix in the g-set appended
for all boundary conditions.
134