NX Nastran DMAP Programmer's Guide - Kxcad.net

796
ASDR
Prints the extra point aerodynamic displacements
ASDR Prints the extra point aerodynamic displacements
Prints the aerodynamic extra point displacements and the aerodynamic pressures and
forces as requested in Case Control.
Format:
ASDR CASEA,UXDAT,AECTRL,FFAJ,ACPT,PAK,AEUSET,AEBGPDT,
AECOMP,MONITOR,MPSR,MPSER,MPSIR,MPSRPS,MPSERPS,
AEMONPT,MPAR,MPAER,AERO,CSTMA//
MACH/Q/AECONFIG/SYMXY/SYMXZ/IUNITSOL $
Input Data Blocks:
CASEA A single record (subcase) of CASECC for aerodynamic analysis.
UXDAT Table of aerodynamic extra point identification numbers,
displacements, labels, type, status, position and hinge moments.
AECTRL Table of aeroelastic model controls.
FFAJ Matrix of pressures at aerodynamic boxes.
ACPT Aerodynamic connection and property table.
PAK Matrix of aerodynamic forces at aerodynamic boxes.
AEUSET Aerodynamic USET table.
AEBGPDT Basic grid point definition table with the aerodynamic degrees of
freedom added (ksa-set in AEUSET).
AECOMP Aerodynamic component definition table.
MONITOR Structural monitor point table
MPSR Rigid aerodynamic loads on structural monitor points at trim (excluding
inertial loads and static applied loads)
MPSER Elastic restrained loads on structural monitor points at trim (excluding
inertial loads and static applied loads)
MPSIR Inertial loads on structural monitor points at trim
MPSRP Rigid loads on structural monitor points due to static applied loads
MPSERP Elastic restrained loads on structural monitor points due to static
applied loads
AEMONPT Aerodynamic monitor point table
MPAR Rigid aerodynamic loads on aerodynamic monitor points at trim