NX Nastran DMAP Programmer's Guide - Kxcad.net

1467
TOLAPP
Appends nonlinear data and Case Control for data recovery
NSKIP Input/output-integer-default=1. CASECC record counter or nonlinear
transient loop identification number.
NEWP Input/output-integer-default=1. New subcase flag.
-1 Current subcase has not been completed.
1 Current subcase has been completed.
POUTF Output-integer-default=1. Intermediate output flag. Set to -1 if
intermediate output is not requested.
Remarks:
1. If TOLAPPF=0, TOLAPP reads the time values from TEL, takes every NSOUT-th
one, and appends these to TOL. The last time value from TEL is appended
regardless of the value of NSOUT. If NSOUT>0 then a maximum of NSOUT time
values are written to TOL.
2. If TOLAPPF=1, TOLAPP reads a record from CASEXX, modifies it, and appends
it to CASECCR. If output has been requested (INTOUT field on the NLPARM
Bulk Data entry) for this load factor TOLAPP appends the current load factor
from ESTNL to OLF.