NX Nastran DMAP Programmer's Guide - Kxcad.net

936
DPD
Creates tables from Bulk Data entry images specified for dynamic analysis
PSDL Power spectral density list.
RCROSSL Table of RCROSS Bulk Data entry images.
UNUSED7 Unused.
NLFT Nonlinear Forcing function table.
TRL Transient response list.
EED Table of eigenvalue extraction parameters.
EQDYN Equivalence table between external and internal grid/scalar/extra
point identification numbers. (EQEXIN appended with extra point
data).
Parameters:
LUSET Input-integer-no default. The number of degrees-of-freedom in the
g-set.
LUSETD Output-integer-no default. The number of degrees-of-freedom in the
p-set.
NOTFL Output-integer-no default. The number of transfer function Bulk Data
entries. Set to -1 if no sets are defined.
NODLT Output-integer-no default. Set to 1 if dynamics loads Bulk Data entries
are processed, -1 otherwise. 1 also means DLT is created.
NOPSDL Output-integer-no default. Set to 1 if random analysis Bulk Data entries
are processed, -1 otherwise. 1 also means PSDL is created.
DATAREC Input-integer-default=0. Data recovery flag. If DATAREC>0, then DPD
will not perform UFM 2071 checks for DELAY and DPHASE which are
not needed in data recovery.
UNUSED6 Input-integer-default=0. Unused.
NONLFT Output-integer-no default. Set to 1 if nonlinear forcing function Bulk
Data entries are processed, -1 otherwise. 1 also means PSDL is created.
NOTRL Output-integer-no default. Set to 1 if transient time step parameter Bulk
Data entries are processed, -1 otherwise. 1 also means TRL is created.
NOEED Output-integer-no default. Set to 1 if eigenvalue extraction Bulk Data
entries are processed, -1 otherwise. 1 also means EED is created.
UNUSED10 Input-integer-no default. Unused.
NOUE Output-integer-no default. Number of extra points. Set to -1 if there are
no extra points.