NX Nastran DMAP Programmer's Guide - Kxcad.net

DRMH3
Partitions tables for each superelement
Remarks:
1. If CASECC is purged, then all input data blocks will be converted. Otherwise, the
inputs will be converted based on the output commands specified in CASECC.
2. If the number of entries in a matrix does not match the associated table, the
following will occur:
If the number of rows (output quantities; e.g., stresses) does not match, a warning
message will be printed with the identification of the matrix and table name.
If the number of columns (e.g., subcases or mode) does not match, then a warning
message will be printed and the module will continue. This will allow the user to
combine modal results using any desired method into a single set of results (or
more) and not be required to modify the table.
Example:
See the “DRMH1” on page 938 module description.
941