NX Nastran DMAP Programmer's Guide - Kxcad.net

SSG1
Computes static load matrix
TABS Input-real-default=0.0. Absolute temperature conversion. For example,
set to 273.16 when specifying temperatures in Celsius or 459.69 in
Fahrenheit.
SEID Input-integer-default=0. Superelement identification number.
Remarks:
1. One static load is built for each CASECC record starting with NSKIP + 1 as long
as the boundary conditions are constant. IF NSKIP ≤ 0, it is set to zero.
2. In SLTH the heat transfer loads REFERENCING ELEMENTS (QVOL, QBDY1,
QBDY2, QBDY3 and QVECT Bulk Data entries) have been converted to applied
load factors and connected grid points.
3. SLT and BGPDT cannot be purged if external static loads or LOAD Bulk Data
entries are selected in CASECC.
4. CSTM cannot be purged if any grid point or load references a coordinate system
other than basic.
5. EST and MPT cannot be purged if thermal or element deformation loads are
selected.
6. ETT cannot be purged if thermal loads are applied.
7. EDT cannot be purged if element deformation loads are selected.
8. MGG cannot be purged if GRAV or RFORCE loads are applied.
9. DIT cannot be purged if temperature-dependent materials are present.
10. UG may be purged, but geometric nonlinear effects will be ignored.
11. PTELEM may be purged.
12. CSTM0 and SCSTM are required to support the MB=-1 on the GRAV and
RFORCE Bulk Data entries.
142