Design and Construction Handbook - Los Angeles World Airports

Guide Specification
PAGING SYSTEMS
27 51 13 - 26
e. Test Resolution: Any discrepancies or problems discovered during these tests
shall be corrected by the Contractor at no cost to the Owner. The problems
identified in each phase shall be corrected and the percentage of the entire system
re-tested determined by the Design Consultant, before any subsequent testing
phase is performed.
C. Performance Verification Testing
1. Complete operational testing of all components and systems shall be witnessed by
designated LAWA Representatives.
2. Schedule test with Design Consultant. Do not begin testing until:
a. All systems have been installed and individually and jointly tested to ensure they
are operating properly.
b. Written permission from Design Consultant has been received.
3. Testing: As part of performance verification, test all components of system. The tests
shall demonstrate system features.
4. Verification: Verify correct operation of the required system functionality as defined in
these specifications.
5. Adjustment, Correction, and Completion:
a. Correct deficiencies and retest affected components.
b. Make necessary adjustments and modification to system after obtaining approval
of the Design Consultant.
c. Completion: Performance verification test shall be complete when testing or
retesting of each component has produced a positive result and has been approved
in writing by the Design Consultant.
6. Recording:
a. Describe actual operational tests performed and equipment used and list personnel
performing tests.
b. Record in tabular form all test results, deficiencies, and corrective measures.
7. Termination
a. Performance verification test shall be terminated by the Design Consultant when:
1) Individual components, subsystems, or the integrated system fail to perform
as specified.
Communication Systems