Design and Construction Handbook - Los Angeles World Airports

Guide Specification
1.3 SUBMITTALS
A. Shop Drawings: Indicate outline and support point dimensions, voltage, main bus ampacity,
integrated short circuit ampere rating, circuit breaker and fusible switch arrangement and
sizes.
B. Product Data: Submit catalog data showing specified features of standard products.
1.4 CLOSEOUT SUBMITTALS
A. Project Record Documents: Record actual locations of panelboards and record actual
circuiting arrangements.
B. Operation and Maintenance Data: Submit spare parts listing; source and current prices of
replacement parts and supplies; and recommended maintenance procedures and intervals.
1.5 QUALIFICATIONS
A. Manufacturer: Company specializing in manufacturing products specified in this section with
minimum five years documented experience.
B. The manufacturer of the panelboard shall be the same manufacturer of the major components
within the assembly, including circuit breakers and fusible switches.
1.6 MAINTENANCE MATERIALS
A. Furnish two of each panelboard key. Panelboards keyed alike to LAWA’s current keying
system.
PART 2 - PRODUCTS
2.1 DISTRIBUTION PANELBOARDS
NOTE: Due to the corrosive exterior environment at the airport, all panelboards are to be
located indoors, as much as possible. In the event that an exterior installation is the only
option, all exterior panelboards are to be a NEMA Type 4 or better.
A. Manufacturers:
1. Cutler-Hammer.
2. GE Electrical.
3. Square D.
B. Product Description: NEMA PB 1, circuit breaker type panelboard.
PANELBOARDS
26 24 16 - 2 Electrical Systems