Design and Construction Handbook - Los Angeles World Airports

Guide Specification
corrective action as being successful, and recommended point for
resumption of testing.
2) After submission of report, schedule review meeting at job site. Schedule
date and time with the Design Consultant.
3) At review meeting, demonstrate that all failures have been corrected by
performing verification tests.
4) Based on report and review meeting, the Design Consultant will direct
Contractor to repeat Phase I, restart Phase I, or proceed to Phase III - Final
Testing.
c. Phase III - Final Testing:
1) Time: 24 hours per day for 15 consecutive calendar days.
2) Make no repairs during this phase unless authorized in writing by Engineer.
.
7. Phase IV - Final Assessment:
1) After conclusion of Phase III or termination of testing, identify all failures,
determine causes, and repair. Submit explaining the nature of each failure,
corrective action taken, results of tests performed, and recommended point
for resumption of testing.
2) After submission of report schedule review meeting at job site. Schedule
date and time with the Design Consultant.
3) At review meeting, demonstrate that all failures have been corrected by
performing verification tests.
4) Based on report and review meeting, the Design Consultant will approve
endurance test or direct Contractor to repeat all or part of Phases III and IV.
8. Adjustment, Correction, and Maintenance
a. During endurance testing make adjustments and corrections to system only after
obtaining written approval of the Design Consultant.
b. During endurance testing, perform required maintenance on systems including
provision of replacement parts.
G. Final Inspection and Acceptance
1. After endurance testing is complete, review tabulated records with the Design Consultant.
ACCESS CONTROL AND ALARM MONITORING SYSTEM (ACAMS)
REQUIREMENTS
28 13 00 - 29
Security Systems