NATIONAL ALUMINIUM COMPANY LIMITED - Rites

as a proof of the final acceptance of the equipment. Such certificate shall not unreasonably
be with held ld nor will the Employer delay the issuance thereof, on account of minor
omissions or defects which do not affect the commercial operation and/or cause any serious
risk to the equipment. Such certificate shall not relieve the Contractor of any of his
obligations ations which otherwise survive, by the terms and conditions of the Contract after
issuance of such certificate.
4.20 TRAINING OF EMPLOYER'S PERSONNEL
The scope of service under training of Employer’s engineers (min. 3 nos.) shall include a
training module in the areas of Operation & Maintenance. Such training should cover the
following areas as a minimum in order to enable these personnel to individually take the
responsibility of operating and maintaining the wagon tippler system in a manner accepta acceptable
to the Employer:
The scope of services under training shall also necessarily include training of Employer's
personnel. This shall cover all disciplines viz, Mechanical, Electrical, C&I, & operation etc. and
shall include all the related areas like Des Design ign familiarization, training on product design
features and product design softwares of major equipment and systems, engineering,
manufacturing, erection, commissioning, training on operating features of equipment,
quality assurance and testing, plant vis visits its and visits to manufacturer's works, exposure to
various kinds of problems which may be encountered in fabrication, manufacturing,
erection, welding etc. The training module prepared by the contractor, shall be submitted
for the Employer’s approval, pri prior to imparting training.
Contractor shall furnish in his offer, details of training module(s) covering above
requirements which shall be subject to Employer's approval. Consolidated training period
included above (for O&M and Engineering) is indicative only. Employer reserves the right to
reappropriate the training period between O&M and engineering depending upon the
details of training module proposed by the Contractor.
Training schedule shall be finalised based on the Contractor's proposal within two (2)
months prior to commissioning.
In all the above cases, wherever the training of Employer's personnel is arranged at the
works of the manufacturer's it shall be noted that the lodging and boarding of the
Employer's personnel shall be at the cost of Co Contractor.
4.21 SAFETY ASPECTS DURING CONSTRUCTION AND ERECTION
In addition to the requirements given in Erection Conditions of Contract (ECC) the following
shall also cover:
1. Working platforms should be fenced and shall have means of access.
2. Ladders in accordance ccordance with Employer’s safety rules for construction and erection shall
be used. Rungs shall not be welded on columns. All the stairs shall be provided with
handrails immediately after its erection.
4.22 NOISE LEVEL
Technical Specifications: Sec-5,General Techn chnical Requirements
Page 23 of 27