NATIONAL ALUMINIUM COMPANY LIMITED - Rites

ELECTRICS FOR WAGON TIPPLER SYSTEM
1.0 SPECIAL INSTRUCTIONS TO BIDDERS
1.1 Inspection of site by Bidder
Bidder shall inspect the site and examine and obtain all information required and satisfy
himself regarding all matters such as access to site, communication, transport, right of way,
the availability of local labour, availability and rates of materials, local working conditions,
extreme weather conditions, uncertainty of weather, obstructions and hindrances that m mmay
arise, etc, which may affect the work or cost thereof, before the submission of his tender.
Ignorance of site conditions shall not be accepted as basis for any claim for compensation.
The submission of tender by Bidder will be construed as evidence tha that t such an examination
was made and any later claims / disputes in regard to price quoted shall not be entertained
or considered.
Bidder shall also indicate in his bid all the major assumptions including major design
assumptions / criteria made by him on which the bid is based.
1.2 Compliance with Specification
All equipment and accessories covered under this specification shall conform to the
“Technical Specifications” given in this document.
In case alternative type of equipment is offered, all technical particulars of equipment
offered, number of such equipment supplied in India, reference list of installations where
such equipment is in operation as per qualifying requirements, type test cer certificates of their
collaborators, type test certificates of indigenously made equipment, extent of import
content and availability of spares indigenously, along with any other data for considering the
alternative equipment shall be furnished with the offer offer. . The Purchaser, however, reserves
the right to accept or reject the proposal without assigning any reason.
All equipment shall be suitable for voltage/frequency variations and other data given in
Electrical System Design.
The contractor shall be responsible for satisfactory working of system with guaranteed
parameters. All the major equipment shall be installed, tested and commissioned under
supervision of representative of manufacturer of respective equipment.
1.3 Standards and Regulations
Technical Specification:Sec-6, Electrical
SECTION 6
Page 1 of 97