navmc dir 5100.8 marine corps occupational safety and ... - US Navy

7003 MARCOR OSH PROGRAM MANUALc. New processes or equipment are identified to the ISO soa job hazard analysis evaluation can be conducted.7004. RESPONSIBILITIES1. CMC, SD. SD shall provide guidance in regard to any changein inspection responsibilities.2. ISO. The manager of the ISO shall provide the installationpolicy regarding inspections. The ISO shall also conduct ordirect the following:a. Work center inspections that meet the minimumrequirements of paragraph 7005.b. Standardized work center safety inspection training. Inaddition to guidance provided by the ISO, this training willinclude on-the-job training in which the work center safetyrepresentative accompanies the ISO on a minimum of one workcenter inspection.b. Standardize work center safety inspection training.Offer inspection technique classes. As available, offer othersafety officers the opportunity to accompany an ISO inspector ona work center inspection.c. Review the previous work center inspection documentationas part of the annual work center inspection process.d. Inspections conducted as a result of requests or reportsby employees of unsafe or unhealthful working conditions,receipt of an ANYMOUSE report, and under the requirements of 29CFR 1960, Department of Labor Regulations on Federal EmployeeOccupational Safety and Health Programs; 29 CFR 1910,Occupational Safety and Health Standards for General Industry;29 CFR 1926, Occupational Safety and Health Standards forConstruction Industry; and this Manual.e. Preparation of NAVMC 11400, OSH Deficiency Notice, forrisk assessment code (RAC) 1, 2, or 3, violations are inaccordance with risk assessment code (RAC) Matrix per paragraph7005 and posted as prescribed in paragraph 7006.7-6