Administrator's Plus Report Cards Manual - Rediker Software, Inc.

Chapter 7
Report Cards Report Writer
Standard Codes for Reports in Report Card Report Writer
Code
~PGNUM:X~
Page Number
Reset
~PRINTPAGEHE
ADER~
Causes the page
header to print on
the report
Description
The page number code (~PG~) is placed in the header or footer of
a report and prints the page number of each page, starting with #1.
The Page Number Reset code allows you to start numbering
pages at a number other than 1. Replace X with the number from
which you will start counting the page numbers, that is, the number
that will print on the first page of the report.
The code is mandatory for the Page Header to print on the page. It
usually appears after the ~PGNUM:X~ code in the report.
• ~SHSTART~: Start of Search Header (printed at the start of
search category)
• ~SHEND: End of Search Header (printed at the end of search
category)
All the lines between the ~SHSTART~ and ~SHEND~ codes make
up the Search Header. The Search Header prints at the beginning
of every new search category. For instance, if you run a report
searching on HOMEROOM and sorted by GENDER, a Search
Header will be printed for each new Homeroom. If the Search
Header contains an ~ENDPAGE~ code, a new page will be printed
for every found search category. If the body of a report contains a
Search Header and no search is performed when running the
report, the Search Header will not be printed.
7-80 Report Cards Manual