Administrator's Plus Report Cards Manual - Rediker Software, Inc.

Chapter D
Skills and Concepts
Box Code Definitions
Box Code Definitions
~AdvancedSpecStart=#~
(Advanced Box)
~AdvancedSpecEnd~
Indicates the start and end of the AdvancedSpecBox specification. Since more than one
Advance Box can be defined in one report, “#” is the specification number for the table.
This number will default to 1 if not specified.
Align=(L,R or C) (Draw Box)
X determines if the information between the ~PrintBox:#~ and ~EndPrintBox:#~ commands
will be left or right justified or centered.
~AttendanceBoxStart=#~
(Attendance Box)
~AtendanceBoxEnd~
Indicates the start and end of the Attendance Box specifications. Since more than one
Advance Box can be defined in one report, “#” is the number for the table. This number
will default to 1 if not specified.
Auto or AutoCalc or AutoCalcAll (Course Table, Advanced
Specifications: General)
If this keyword is present in the procedure code, the program ignores all the heights and
widths of all the boxes specified. Dimensions of the all the boxes are determined by the
program based on the page height and page width. The default is to include it in the procedure.
Adding ~REM~ before the statement means the program will ignore this line.
BlankLineBeforeHeader=Y or N
(AdvancedSpecifications: Course)
To print a blank line before the skills heading, set this to “Y” for Yes. The default is
“N” for No.
BodyFont
(Attendance, Course Table,
Advanced Specifications: Course,
Comment, Concepts, Narrative, GPA &
Honor Roll)
To change the font and size of the Body, set the word “BodyFont” to the desired font
and size required for the report. If this specification is omitted from the code, the default
is black, Arial, 8 pitch and bold.
BorderWidth=#
(Draw Box, GPA & Honor Roll)
Defines the width of the border using a range of 0-3, 0 is the thinnest and 3 is the thickest.
LeftBorderWidth=#
(Attendance, Course Table,
Advanced Specifications:
Draw BoxRightBorderWidth=#
course, comments, concepts
and narratives)
TopBorderWidth=#
BottomBorderWidth=#
These four parameters set the width of the box border. The setting range is from 0 to 3,
0 being the thinnest and 3 the thickest. Each side of the box can be set separately.
D-32 Report Cards Manual