Administrator's Plus Report Cards Manual - Rediker Software, Inc.

Skills and Concepts
Box Code Definitions
BoxGap=#.##
(GPA)
This parameter defines in inches the horizontal spacing between individual cells. The
default is 0.1 inch. BoxHeight=#.## or Auto
(Draw Box, Attendance,
Course Table, GPA, Honor Roll)
The maximum height of a course table, or, in the case of an advanced specification table,
the height of the course section, comment section, or narrative section. Do not confuse
the height of each course row with the course section. Rows that will not fit in this
height will be truncated. Box Height is set in inches.
BoxHeight=#.##
(Image)
Defines the width of the image, provided the Stretch parameter is set as “Y”. If the image
should not be stretched, then the image's aspect ratio will be maintained and the size
will be adjusted to best fit in the given Width and Height. Setting of BoxWidth & Box-
Height causes the Zoom parameter to be ignored.
BoxWidth=#.## or Auto
(Draw Box, Attendance, Course
Table, Advanced Specification:
General, GPA, Honor Roll)
Indicates the width of the cell. In the Advanced Specification box, it also defines globally
the width of all the different cells (course, comment, concept, and narrative). Columns
that will not fit in this width will be truncated. Boxwidth is defined in inches.
Default is Auto.
CellHeight=#.## or Auto
(Draw Box, Advanced
Specifications: Course, Comment,
Concepts, Narrative)
The maximum height of a course cell, or, in the case of an advanced specification table,
the height of the course section, comment section, or narrative section. Do not confuse
the height of each course row with the course section. Rows that will not fit in this
height will be truncated. Cell Height is set in inches.
CellGapAcross=#.##
(Advanced Specifications:
General)
This parameter determines the vertical spacing in inches between cells. The default is 0
CellGapDown=#.##
(Advanced Specifications:
General)
The horizontal spacing between cells. Parameter type is in inches. Default is 0
CharPerColumn=3 or 5
(Advanced Specifications:
Courses)
Set the command to 3 if the desired column header for the marking period is three characters.
Set the command to 5 if you prefer the 5 character column header for the marking
period. The 3 and 5 column headers are defined in the Customized RC, Customize
Report Card Columns program.
ColumnContents=Qtr1,Qtr2,Qtr3, Qtr4,Qtr5,Qtr6,RCSpec Range, YTD,Total
(Attendance)
Any or all of these parameters may be printed in any order separated by commas. Qtr1-
6 prints the attendance for the specified quarter based on the quarter ending dates in the
Calendar program. RCSpecRange prints the attendance between and including the
dates specified in the Report Card Report Writer, Specs #A & #B. YTD (Year-to-Date)
prints the attendance through the date listed in the RCRW Spec. #C. Total prints the attendance
for the year.
Report Cards Manual D-33