Administrator's Plus Report Cards Manual - Rediker Software, Inc.

Chapter 2
Enter Courses
Inspect/Change Specifications
PAGE 2: More Specifications
Specification
1) PRINT
DEFAULTS FOR
A NEW
SECTION
2) AFTER
ENTERING A
SECTION, ADD
ANOTHER
SECTION
3) PRINT
DESCRIPTION
ON MASTER
COURSE
PRINTOUT
Description
When adding a new section, Report Cards Plus can save you a few
keystrokes by printing as the defaults for the new section the same
teacher, room and meeting time that the previous section for that
course has. You may then accept or type over these defaults. If you
do not want default settings to appear when you add a new section,
set this specification to No.
To add a new section of a course, you will need to choose F2: ADD.
If this specification is set to No, you will need to press F2: ADD each
time you want to add a new section to a course. If this specification
is set to “Yes”, after you create a section, another new section will
automatically be added. When you are finished, press ESC to cause
the last additional section to be erased and leave the add mode.
If you choose to include the 40 character course description on your
master course printout, the print will be condensed to allow it to fit
properly on a page.
2-22 Report Cards Manual