ModelSim SE User's Manual - Electrical and Computer Engineering

Preference variables located in INI files UM-533
Variable name Value range Purpose Default
NumericStdNoWarnings 0, 1 if 1, warnings generated within the
accelerated numeric_std and numeric_bit
packages are suppressed; this variable can
be set interactively with the Tcl set
command (UM-477)
PathSeparator any character
except those with
special meaning
(i.e., \, {, }, etc.)
Resolution fs, ps, ns, us, ms,
or sec with
optional prefix of
1, 10, or 100
used for hierarchical pathnames; must not
be the same character as DatasetSeparator;
this variable can be set interactively with
the Tcl set command (UM-477)
simulator resolution; no space between
value and units (i.e., 10fs, not 10 fs);
overridden by the -t argument to vsim (CR-
373); if your delays get truncated, set the
resolution smaller; this value must be less
than or equal to the UserTimeUnit
(described below)
RunLength positive integer default simulation length in units specified
by the UserTimeUnit variable; this variable
can be set interactively with the Tcl set
command (UM-477)
Show3DMem 0, 1 controls whether or not arrays of 3 or more
dimensions are listed as memories in the
Memory pane; this variable can be set with
the Tcl set command (UM-477)
ShowIntMem 0, 1 controls whether or not integer arrays are
listed as memories in the Memory pane; this
variable can be set with the Tcl set
command (UM-477)
ShowEnumMem 0, 1 controls whether or not enumerated type
arrays (other than std_logic-based arrays)
are listed as memories in the Memory pane;
this variable can be set with the Tcl set
command (UM-477)
ShowUnassociatedScNameWa
rning
ShowUndebuggableScTypeWa
rning
0, 1 if 1, displays unassociated SystemC name
warnings
0, 1 if 1, displays undebuggable SystemC type
warnings
SimulateAssumeDirectives 0, 1 if 1, PSL assume directives are simulated as
if they were assert directives; see
"Processing assume directives in
simulation" (UM-363) for more information
off (0)
/
ns
100
on (1)
on (1)
on (1)
off (1)
on (1)
on (1)
ModelSim SE User’s Manual