FTOS Configuration Guide for the C-Series - Force10 Networks

Example of SNMP Set
The example below creates vlan 10.
abcServer > snmpset -c public 123.45.6.78 .1.3.6.1.2.1.17.7.1.4.3.1.5.10 i 4
SNMPv2-SMI::mib-2.17.7.1.4.3.1.5.10 = INTEGER: 4
Figure 46 displays the show vlan output.
Force10# show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
10 Inactive
Force10#
Figure 46 show vlan command
SNMP output
abcServer > snmpwalk -c public 123.34.5.67 .1.3.6.1.2.1.17.7.1.4.3.1.1
SNMPv2-SMI::mib-2.17.7.1.4.3.1.1.1107787777 = STRING: "Vlan 1"
SNMPv2-SMI::mib-2.17.7.1.4.3.1.1.1107787786 = STRING: "Vlan 10"
Assign line card ports
Use the FTOS interface range command to assign ports in line card 0, 1, and 2 as Layer 2 ports.
Force10(conf)#inteface range gi 0/0 - 23
Force10(conf-if-range-gi-0/0-23)#switchport
Force10(conf-if-range-gi-0/0-23)#interface range gi 1/0 - 23
Force10(conf-if-range-gi-1/0-23)#switchport
Force10(conf-if-range-gi-1/0-23)#interface range gi 2/0 - 23
Force10(conf-if-range-gi-2/0-23)#switchport
Force10(conf-if-range-gi-2/0-23)#end
Mar 17 11:14:01: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by
console - repeated 2 times
Force10#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive U Gi 0/0-23
U Gi 1/0-23
U Gi 2/0-23
Force10#
10 Inactive
Figure 47 interface range command
100 Simple Network Management Protocol (SNMP)