FTOS Configuration Guide for the C-Series - Force10 Networks

Figure 205 is a sample output from the show sflow linecard command:
Figure 205 show sflow linecard Command Example
Specifying Collectors
The sflow collector command allows identification of sFlow Collectors to which sFlow datagrams are
forwarded. The user can specify up to two sFlow collectors. If two Collectors are specified, the samples are
sent to both.
Collection through Management interface is supported on platform e.
Polling Intervals
.
Force10#show sflow linecard 1
Linecard 1
Samples rcvd from h/w :165
Samples dropped for sub-sampling :69
Total UDP packets exported :77
UDP packets exported via RPM :77
UDP packets dropped :
Command Syntax Command Mode Usage
sflow collector ip-address
agent-addr ip-address [number
[max-datagram-size number] ] |
[max-datagram-size number ]
CONFIGURATION Identify sFlow collectors to which sFlow
datagrams are forwarded.
Default UDP port: 6343
Default max-datagram-size: 1400
The sflow polling-interval command configures the polling interval for an interface in the maximum
number of seconds between successive samples of counters to be sent to the collector. This command
changes the global default counter polling (20 seconds) interval. You can configure an interface to use a
different polling interval.
The polling interval can be configured globally (in CONFIGURATION mode) or by interface (in
INTERFACE mode) by executing the interval command:
Command Syntax Command Mode Usage
sflow polling-interval
interval value
CONFIGURATION
or
INTERFACE
Change the global default counter polling interval.
interval value—in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
FTOS Configuration Guide, version 7.7.1.0 307