FTOS Configuration Guide for the C-Series - Force10 Networks

To add routes from other routing instances or protocols, use any of the following commands in the
ROUTER RIP mode:
Command Syntax Command Mode Purpose
redistribute {connected | static} [metric
metric-value] [route-map map-name]
redistribute isis [level-1 | level-1-2 | level-2]
[metric metric-value] [route-map map-name]
redistribute ospf process-id [match external
{1 | 2} | match internal] [metric value]
[route-map map-name]
To view the current RIP configuration, use the show running-config command in the EXEC mode or
the show config command in the ROUTER RIP mode.
Set send and receive version
To specify the RIP version, use the version command in the ROUTER RIP mode. To set an interface to
receive only one or the other version, use the ip rip send version or the ip rip receive version
commands in the INTERFACE mode.
To change the RIP version globally in FTOS, use the following command in the ROUTER RIP mode:
Command Syntax Command Mode Purpose
ROUTER RIP Include directly connected or
user-configured (static) routes in RIP.
• metric range: 0 to 16
• map-name: name of a configured
route map.
ROUTER RIP Include IS-IS routes in RIP.
• metric range: 0 to 16
• map-name: name of a configured
route map.
ROUTER RIP Include specific OSPF routes in RIP.
Configure the following parameters:
• process-id range: 1 to 65535
• metric range: 0 to 16
• map-name: name of a configured
route map.
version {1 | 2} ROUTER RIP Set the RIP version sent and received on the
system.
You can set one RIP version globally on the system. This command sets the RIP version for RIP traffic on
the interfaces participating in RIP unless the interface was specifically configured for a specific RIP
version.
Use the show config command in the ROUTER RIP mode to see whether the version command is
configured. You can also use the show ip protocols command in the EXEC mode to view the routing
protocols configuration.
448 Routing Information Protocol