FTOS Configuration Guide for the C-Series - Force10 Networks

configure FTP client parameters
To configure FTP client parameters, use the following commands in the CONFIGURATION mode:
Command Syntax Command Mode Purpose
ip ftp source-interface
interface
To view FTP configuration, use the show running-config ftp command (Figure 31) in the EXEC privilege
mode.
Diagnostics
When you enable the diag command, the sequence of actions is:
1. you must confirm that you want to run diagnostics on a line card, RPM, or SFM.
2. the FTOS stops network traffic on the card.
3. the FTOS downloads the diagnostics, and diagnostics begin.
You cannot enable the diag command on a nonredundant RPM. If there is only one RPM in the E-Series
system, you must take the RPM offline and then configure the diag command.
Configuration Task List for Diagnostics
The following list includes the configuration tasks for diagnostics:
• enable diagnostics on an RPM on page 80 (optional)
CONFIGURATION Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a loopback interface, enter the keyword
loopback followed by a number between 0 and
16383.
• For a port channel interface, enter the keyword
port-channel followed by a number from 1 to 255
for TeraScale, 1 to 32 for EtherScale.
• For a SONET interface, enter the keyword sonet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet followed by the slot/
port information.
• For a VLAN interface, enter the keyword vlan
followed by a number from 1 to 4094.
ip ftp password password CONFIGURATION Configure a password.
ip ftp username name CONFIGURATION Enter username to use on FTP client.
FTOS Configuration Guide, version 7.7.1.0 79