FTOS Configuration Guide for the C-Series - Force10 Networks

To enter the LINE mode to configure a terminal connection, use one of the following commands in the
CONFIGURATION mode:
Command Syntax Command Mode Purpose
line aux 0 CONFIGURATION Enter the LINE mode to configure an auxiliary
terminal line.
line console 0 CONFIGURATION Enter the LINE mode for the console port.
line vty number [end-number] CONFIGURATION Enter the LINE mode to configure virtual
terminals. FTOS supports up to 10 virtual
terminals for Telnet sessions. Specify a number
from 0 to 9 for the virtual terminal.
To configure multiple virtual terminals, enter an
end number. For example, to enter and
configure virtual terminals 0 through 3, enter
line vty 0 3.
To view the current configuration for the terminal connection, enter show config in the LINE mode.
Figure 35 shows the configuration for three virtual terminal lines.
Figure 35 show config Command Example for Multiple VTY Terminal Lines
You cannot delete a terminal connection.
filter traffic on a line
Use only Standard ACLs in the access-class command to filter traffic on Telnet sessions.
To configure and assign an IP ACL to a line, use these commands in the following sequence, starting in the
CONFIGURATION mode:
Step Command Syntax Command Mode Purpose
1 line vty number [end-number] CONFIGURATION Enter the LINE mode. To configure
multiple virtual terminals, enter an end
number. For example, to enter and
configure vitriol terminals 0 through 3,
enter line vty 0 3.
2
Force10(config-line-vty)#show config
line vty 0
line vty 1
line vty 2
Force10(config-line-vty)#
ip access-group access-list name CONFIGURATION Assign a configured Standard ACL to
the line.
FTOS Configuration Guide, version 7.7.1.0 83