FTOS Configuration Guide for the C-Series - Force10 Networks

Figure 209 show ip interface Command Example
Force10#show ip int gi 0/8
GigabitEthernet 0/8 is up, line protocol is up
Internet address is 10.69.8.1/24
Broadcast address is 10.69.8.255
Address determined by config file
MTU is 1554 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Force10#
Configure static routes
A static route is an IP address that is manually configured and not learned by a routing protocol, such as
OSPF. Often static routes are used as backup routes in case other dynamically learned routes are
unreachable.
To configure a static route, use the following command in the CONFIGURATION mode:
Command Syntax Command Mode Purpose
ip route ip-address mask {ip-address |
interface [ip-address]} [distance]
[permanent] [tag tag-value]
You can enter as many static IP addresses as necessary.
CONFIGURATION Configure a static IP address. Use the
following required and optional parameters:
• ip-address: Enter an address in dotted
decimal format (A.B.C.D).
• mask: Enter a mask in slash prefix-length
format (/X).
• interface: Enter an interface type followed
by slot/port information.
• distance range: 1 to 255 (optional).
• permanent: Keep the static route in the
routing table (if interface option is used)
even if the interface with the route is
disabled. (optional)
• tag tag-value range: 1 to 4294967295.
(optional)
316 IP Addressing