FTOS Configuration Guide for the C-Series - Force10 Networks

Redistribute routes
You can add routes from other routing instances or protocols to the OSPF process. With the redistribute
command syntax, you can include RIP, static, or directly connected routes in the OSPF process.
Use the following command in CONFIGURATION- ROUTER-OSPF mode to redistribute routes:
Command Syntax Command Mode Usage
redistribute {bgp | connected |
isis | rip | static} [metric
metric-value | metric-type
type-value] [route-map map-name]
[tag tag-value]
CONFIG-ROUTER-
OSPF
Figure 391 Command Example: show config To view the current OSPF configuration, use the show
running-config command in the EXEC mode or the show config command in the ROUTER OSPF
mode.
Force10(conf-router_ospf)#show config
!
router ospf 34
network 10.1.2.32 0.0.0.255 area 2.2.2.2
network 10.1.3.24 0.0.0.255 area 3.3.3.3
distribute-list dilling in
Force10(conf-router_ospf)#
Specify which routes will be redistributed into
OSPF process. Configure the following required
and optional parameters:
• bgp, connected, isis, rip, or static: enter
one of the keyword to redistribute those
routes. rip is supported only on E-Series.
• metric metric-value range: 0 to
4294967295.
• metric-type metric-type: 1 for OSPF
external route type 1 or 2 for OSPF external
route type 2.
• route-map map-name: enter a name of a
configured route map.
• tag tag-value range: 0 to 4294967295.
FTOS Configuration Guide, version 7.7.1.0 553