02.10.2013 Views

FTOS Configuration Guide for the C-Series - Force10 Networks

FTOS Configuration Guide for the C-Series - Force10 Networks

FTOS Configuration Guide for the C-Series - Force10 Networks

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Displaying Only Configured Interfaces<br />

The following options have been implemented <strong>for</strong> show [ip | running-config] interfaces commands <strong>for</strong><br />

(only) linecard interfaces. When <strong>the</strong> configured keyword is used, only interfaces that have non-default<br />

configurations are displayed. Dummy linecard interfaces (created with <strong>the</strong> linecard command) are treated<br />

like any o<strong>the</strong>r physical interface.<br />

Figure lists <strong>the</strong> possible show commands that have <strong>the</strong> configured keyword available:<br />

Figure 177 show Commands with configured Keyword Examples<br />

<strong>Force10</strong>#show interfaces configured<br />

<strong>Force10</strong>#show interfaces linecard 0 configured<br />

<strong>Force10</strong>#show interfaces gigabitE<strong>the</strong>rnet 0 configured<br />

<strong>Force10</strong>#show ip interface configured<br />

<strong>Force10</strong>#show ip interface linecard 1 configured<br />

<strong>Force10</strong>#show ip interface gigabitE<strong>the</strong>rnet 1 configured<br />

<strong>Force10</strong>#show ip interface br configured<br />

<strong>Force10</strong>#show ip interface br linecard 1 configured<br />

<strong>Force10</strong>#show ip interface br gigabitE<strong>the</strong>rnet 1 configured<br />

<strong>Force10</strong>#show running-config interfaces configured<br />

<strong>Force10</strong>#show running-config interface gigabitE<strong>the</strong>rnet 1 configured<br />

Configuring a Sampling Size<br />

Use <strong>the</strong> rate-interval command, in INTERFACE mode, to configure <strong>the</strong> number of seconds of traffic<br />

statistics to display in <strong>the</strong> show interfaces output.<br />

Although you can enter any value between 30 and 299 seconds (<strong>the</strong> default), software polling is done once<br />

every 15 seconds. So, <strong>for</strong> example, if you enter “19”, you will actually get a sample of <strong>the</strong> past 15 seconds.<br />

All <strong>the</strong> LAG members inherit <strong>the</strong> rate interval configuration from <strong>the</strong> LAG.<br />

<strong>FTOS</strong> <strong>Configuration</strong> <strong>Guide</strong>, version 7.7.1.0 273

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!