FTOS Configuration Guide for the C-Series - Force10 Networks

9
[no] log-only CONFIGURATION
(conf-callhome-
actionlist-name)
Table 63 shows the the three test groups:
Table 63 FTSA Test Lists
(OPTIONAL) Use this command if you want
FTSA data to be collected in a local log rather
than to be sent to configured FTSA recipients.
Note: If there is no space in the flash, this
functionality will fail but will not impact other FTSA
tasks.
SFM status transition from active to
other state
SWP Timeout CPU usage greater than threshold
Line card transition from active to other
state
IPC Timeout System crash
Port-pipe error or transition to down IRC timeout Task crash
RPM status transition from active to
other state
PEM transition from up to other state Memory usage greater than threshold
AC power supply transition from up to
other state
Fan tray down or individual fan down
Overtemp of any item listed in show
environment
Over/under-voltage of any item listed in
show environment
CPU usage greater than threshold Dump, reload due to error, RPM failover
due to error
If any one event occurs in the selected test list, the action list associated with it is invoked.
Table 64 shows the data collected by the three action sets:
Table 64 FTSA Action Sets (Sets of show Commands)
show tech show tech show tech
show trace show trace show trace
show trace hardware show trace hardware show trace hardware
show logging driverlog linecard show process
show process
(all installed LC slots)
communication lp
communication lp (
(for each LC installed slot)
for each LC installed slot)
show logging driverlog cp show processes ipc
show processes ipc
flow-control
flow-control
show console lp
show processes ipc
(all installed LC slots)
flow-control lp (all installed slots)
show pcdfo
show environment linecard-voltage
664 Force10 Service Agent