FTOS Configuration Guide for the C-Series - Force10 Networks

Figure 44 shows the command syntax using MIB object names, and Figure 45 shows the same command
using the object OIDs. In both cases, the object is followed by same index number used in the snmpset
command.
Figure 44 Obtaining MIB Object Values for a Copy Operation using Object-name Syntax
> snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140 copyTimeCompleted.110
FORCE10-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31
Figure 45 Obtaining MIB Object Values for a Copy Operation using OID Syntax
> snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110
SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831) 3:16:38.31
Managing VLANs using SNMP Set in Q-Bridge MIB
The Q-Bridge MIB Set allows you to use the SNMP Set feature to maintain VLANs on platform e .
You can:
• Assigning access and configuring Layer 2 ports on page 99
• Add tagged ports using SNMP Set on page 101
• Changing Administrative Status with SNMP Set on page 105
To manage a VLAN using the VLAN Static table in the Q-Bridge MIB, use the following procedures.
Assigning access and configuring Layer 2 ports
Before using the SNMP Set to manage the FTOS VLANs, use the FTOS commands below to ensure all
interfaces are switch port.
Step Task
1 Execute the FTOS command to assign read/write access from the global
CONFIGURATION mode:
Force10(conf)# snmp-server community public rw
2 Set the port range for your Layer 2 ports:
Force10(conf)# interface range gi 0/0 - 48
3 Set the ports to Layer 2 ports:
Force10(conf-if-gi-0/0- 48)# switchport
FTOS Configuration Guide, version 7.7.1.0 99