FTOS Configuration Guide for the C-Series - Force10 Networks

Show debounce times in an interface
show interface debounce [type]
[slot/port]
Figure 184 Showing .Debounce Time
Force10#
Force10#show interfaces debounce gigabitethernet 3/1
Interface Time(ms)
GigabitEthernet 3/1 200
Force10#
Disabling ports when one only SFM available (E300 only)
Selected ports can be shut down when a single SFM is available on the E300 system. Each port to be shut
down must be configured individually.
When an E300 system boots up and a single SFM is active this configuration, any ports configured with
this feature will be shut down. All other ports are booted up.
Similarly, if an SFM fails (or is removed) in an E300 system with two SFM, ports configured with this
feature will be shut down. All other ports are treated normally.
When a second SFM is installed or replaced, all ports are booted up and treated as normally. This feature
does not take affect until a single SFM is active in the E300 system.
Disable port on one SFM
EXEC Privilege Show the debounce time fpr the specified interface.
Enter the interface type keyword followed by the
type of interface and slot/port information:
• For a 10/100/1000 Ethernet interface, enter
the keyword GigabitEthernet followed by the
slot/port information.
• For a Gigabit Ethernet interface, enter the
keyword GigabitEthernet followed by the slot/
port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet followed by the
slot/port information.
Note: FTOS rounds the entered debounce time up to the nearest hundredth. Note in
Figure 183 thetimer was set at 150 ms, but appears as 200 in Figure 184.
This feature must be configured to each interface you wish to shut down in the case of SFM disabling.
Command Syntax Command Mode Purpose
disable-on-sfm-failure INTERFACE Disables the port when a single SFM only is
available.
280 Interfaces