FTOS Configuration Guide for the C-Series - Force10 Networks

Step Command Syntax Command Mode Purpose
2
3
line {aux 0 | console 0 | vty number
[end-number]}
login authentication {method-list-name
| default}
Figure 36 shows the steps used to configure a password and login authentication scheme for three virtual
terminals.
Figure 36 Commands to Configure Login Authentication and Password
limit IP traffic on a terminal connection
CONFIGURATION Enter one or more terminal lines.
LINE Use the same method-list-name that
you entered in Step 1 or enter default.
For example, if you entered test as the
name of the authentication scheme in
Step 1, enter test as the name in this
step.
This command does not appear in the
LINE mode unless you configured the
aaa authentication login command.
4 password password LINE Enter a text string to be used as a
password. Users on that terminal line
are prompted for this password.
5
show config LINE View the configuration.
Force10(conf)#aaa authentication login suzanne line
Force10(conf)#line vty 0 2
Force10(config-line-vty)#login authent suzanne
Force10(config-line-vty)#password dilling
Force10(config-line-vty)#show confi
line vty 0
password dilling
login authentication suzanne
line vty 1
password dilling
login authentication suzanne
line vty 2
password dilling
login authentication suzanne
Force10(config-line-vty)#
You can apply a standard IP ACL to a terminal line to limit IP traffic over that terminal connection.
To assign a standard IP ACL, use the following command in the LINE mode:
Command Syntax Command Mode Purpose
access-class access-list-name LINE Apply a standard IP ACL to a terminal connection.
To view a terminal line configuration, use the show config command in the LINE mode.
FTOS Configuration Guide, version 7.7.1.0 85