FTOS Configuration Guide for the C-Series - Force10 Networks

The default action is permit and the default sequence number starts at 10. When the keyword deny is used
in configuring a route map, routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in the ROUTE-MAP mode (Figure 244).
Figure 244 Command Example: show config in the ROUTE-MAP Mode
Force10(config-route-map)#show config
!
route-map dilling permit 10
Force10(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the route
maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a
configured route map is applied to a command, like redistribute, traffic passes through all instances of
that route map until a match is found. Figure 245 shows an example with two instances of a route map.
Figure 245 Command Example: show route-map with Multiple Instances of a Route Map
Force10#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Force10#
To delete all instances of that route map, use the no route-map map-name command. To delete just one
instance, add the sequence number to the command syntax (Figure 246).
Figure 246 Deleting One Instance of a Route Map
Force10(conf)#no route-map zakho 10
Force10(conf)#end
Force10#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Force10#
Route map zakho has two
instances
FTOS Configuration Guide, version 7.7.1.0 359