FTOS Configuration Guide for the C-Series - Force10 Networks

The show ip protocols command example Figure 322 confirms that both versions are sent out that
interface. This interface no longer sends and receives the same RIP versions as FTOS does globally.
Figure 322 show ip protocols Command Example
Force10#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
FastEthernet 0/0 2 1 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
Force10#
Generate a default route
Traffic is forwarded to the default route when the traffic’s network is not explicitly listed in the routing
table. Default routes are not enabled in RIP unless specified. Use the default-information originate
command in the ROUTER RIP mode to generate a default route into RIP. In FTOS, default routes received
in RIP updates from other routes are advertised if the default-information originate command is
configured.
To configure FTOS to generate a default route, use the following command in the ROUTER RIP mode:
Command Syntax Command Mode Purpose
default-information originate [always]
[metric value] [route-map route-map-name]
Different RIP
versions configured
for this interface
RIPv2 configured
globally
ROUTER RIP Specify the generation of a default
route in RIP. Configure the following
parameters:
• always: enter this keyword to
always generate a default route.
• value range: 1 to 16.
• route-map-name: name of a
configured route map.
Use the show config command in the ROUTER RIP mode to confirm that the default route configuration
is completed.
450 Routing Information Protocol