MVME5100 Single Board Computer Programmer's Reference Guide

More documents

Recommendations

Info

2 Hawk PCI Host Bridge & Multi-Processor Interrupt Controller edge of CLK after RST_ has been released. All of the sampled pins are cascaded with several layers of registers to eliminate problems with hold time. Table 2-15 summarizes the hardware configuration options that relate to the PHB. Table 2-15. PHB Hardware Configuration Function Sample Pin(s) Sampled State Meaning PCI 64-bit Enable REQ64_ 0 64-bit PCI Bus 1 32-bit PCI Bus PPC Register Base RD[5] 0 Register Base = $FEFF0000 1 Register Base = $FEFE0000 MPIC Interrupt Type RD[7] 0 Parallel Interrupts 1 Serial Interrupts PPC Arbiter Mode RD[8] 0 Disabled 1 Enabled PCI Arbiter Mode RD[9] 0 Disabled 1 Enabled PPC:PCI Clock Ratio RD[10:12] 000 Reserved 100 1:1 010 2:1 110 3:1 001 3:2 101 Reserved 011 5:2 111 Reserved 2-50 <strong>Computer</strong> Group Literature Center Web Site
Multi-Processor Interrupt Controller (MPIC) Multi-Processor Interrupt Controller (MPIC) MPIC Features: Architecture The MPIC is a multi-processor structured intelligent interrupt controller. ❏ MPIC programming model ❏ Supports two processors ❏ Supports 16 external interrupts ❏ Supports 15 programmable Interrupt & Processor Task priority levels ❏ Supports the connection of an external 8259 for ISA/AT compatibility ❏ Distributed interrupt delivery for external I/O interrupts ❏ Direct/Multicast interrupt delivery for Interprocessor and timer interrupts ❏ Four Interprocessor Interrupt sources ❏ Four timers ❏ Processor initialization control The PCI Slave of the PHB implements two address decoders for placing the MPIC registers in PCI IO or PCI Memory space. Access to these registers requires PPC and PCI bus mastership. These accesses include interrupt and timer initialization and interrupt vector reads. The MPIC receives interrupt inputs from 16 external sources, four interprocessor sources, four timer sources, and one Hawk internal error interrupt source. The externally sourced interrupts 1 through 15 have two modes of activation; low level or active high positive edge. External interrupt 0 can be either level or edge activated with either polarity. The Hawk internal error interrupt request is an active low level sensitive interrupt. The Interprocessor and timers interrupts are event activated. http://www.motorola.com/computer/literature 2-51 2
Page 1 and 2:
MVME5100 Single Board Computer Prog
Page 3 and 4:
Safety Summary The following genera
Page 5 and 6:
CE Notice (European Community) Moto
Page 7 and 8:
Contents About This Manual Summary
Page 9 and 10:
PCI Slave .........................
Page 11 and 12:
Spurious Vector Register...........
Page 13 and 14:
Address Parity Error Log Register .
Page 15:
List of Figures Figure 1-1. MVME510
Page 18 and 19:
xviii Table 2-13. Address Modificat
Page 21 and 22:
About This Manual The MVME5100 Sing
Page 23 and 24:
Part Number Description MVME761-011
Page 25 and 26:
8259 Interrupts, and a description
Page 27:
In this manual, assertion and negat
Page 30 and 31:
1 Product Data and Memory Maps Main
Page 32 and 33:
1 Product Data and Memory Maps Memo
Page 34 and 35:
1 Product Data and Memory Maps Tabl
Page 36 and 37:
1 Product Data and Memory Maps PCI
Page 38 and 39:
1 Product Data and Memory Maps L2 C
Page 40 and 41:
1 Product Data and Memory Maps conn
Page 42 and 43:
1 Product Data and Memory Maps to i
Page 44 and 45:
1 Product Data and Memory Maps Requ
Page 46 and 47:
1 Product Data and Memory Maps PROC
Page 48 and 49:
1 Product Data and Memory Maps The
Page 50 and 51:
1 Product Data and Memory Maps Tabl
Page 52 and 53:
1 Product Data and Memory Maps Stat
Page 54 and 55:
1 Product Data and Memory Maps MODR
Page 56 and 57:
1 Product Data and Memory Maps NVRA
Page 58 and 59:
1 Product Data and Memory Maps Geog
Page 60 and 61:
1 Product Data and Memory Maps Boar
Page 62 and 63:
1 Product Data and Memory Maps IPMC
Page 64 and 65:
1 Product Data and Memory Maps Z853
Page 66 and 67:
1 Product Data and Memory Maps IDRE
Page 69 and 70: 2Hawk PCI Host Bridge & Multi- Proc
Page 71 and 72: Block Diagram PCI Bus MPIC Interfac
Page 73 and 74: PPC Bus Interface Functional Descri
Page 75 and 76: PPC Slave Functional Description Ea
Page 77 and 78: PPC FIFO PPC Transfer Type Transfer
Page 79 and 80: Functional Description Table 2-2. P
Page 81 and 82: Table 2-4. PPC Master Read Ahead Op
Page 83 and 84: PPC Arbiter Pin Name Functional Des
Page 85 and 86: PPC Parity Functional Description T
Page 87 and 88: PCI Bus Interface PCI Address Mappi
Page 89 and 90: Functional Description Each map dec
Page 91 and 92: Command Types: Functional Descripti
Page 93 and 94: Fast Back-to-Back Transactions Func
Page 95 and 96: Functional Description It should be
Page 97 and 98: Functional Description The PCI Mast
Page 99 and 100: . Figure 2-6. PCI Spread I/O Addres
Page 101 and 102: Functional Description The device t
Page 103 and 104: Functional Description The Hawk’s
Page 105 and 106: Functional Description Notes 1. “
Page 107 and 108: . DH07-00 DH15-08 DH23-16 DH31-24 F
Page 109 and 110: Error Handling Functional Descripti
Page 111 and 112: Functional Description When not bei
Page 113 and 114: Functional Description PPC1-Bug>md
Page 115 and 116: Functional Description From the per
Page 117: Functional Description ❏ Write po
Page 121 and 122: CSR’s Readability Multi-Processor
Page 123 and 124: Interprocessor Interrupts (IPI) 825
Page 125 and 126: Multi-Processor Interrupt Controlle
Page 127 and 128: Program Visible Registers Multi-Pro
Page 129 and 130: Multi-Processor Interrupt Controlle
Page 131 and 132: Reset State Multi-Processor Interru
Page 133 and 134: EOI Register Multi-Processor Interr
Page 135 and 136: Registers Registers This section pr
Page 137 and 138: Bit ---> Table 2-16. PPC Register M
Page 139 and 140: General Control-Status/Feature Regi
Page 141 and 142: PPC Arbiter/PCI Arbiter Control Reg
Page 143 and 144: Registers PRKx Parking. This field
Page 145 and 146: Hardware Control-Status/Prescaler A
Page 147 and 148: PPC Error Test/Error Enable Registe
Page 149 and 150: Registers XBTOI PPC Address Bus Tim
Page 151 and 152: Registers PPER PCI Parity Error. Th
Page 153 and 154: PPC Error Attribute Register Regist
Page 155 and 156: PCI Interrupt Acknowledge Register
Page 157 and 158: PPC Slave Offset/Attribute (0, 1 an
Page 159 and 160: The fields within XSADD3 are define
Page 161 and 162: Registers KEY Key. This field is us
Page 163 and 164: PPC6-Bug>mw feff0068 aa88;h Effecti
Page 165 and 166: PCI Registers 3 1 3 0 2 9 2 8 2 7 2
Page 167 and 168: PCI Command/ Status Registers Regis
Page 169 and 170:
Revision ID/ Class Code Registers O
Page 171 and 172:
The MPIC Memory Base Address Regist
Page 173 and 174:
Registers INV Invalidate Enable. If
Page 175 and 176:
Conceptual perspective from the PCI
Page 177 and 178:
Registers CONFIG_DATA Register The
Page 179 and 180:
3 1 3 0 2 9 2 8 2 7 2 6 2 5 Table 2
Page 181 and 182:
3 1 3 0 2 9 2 8 2 7 Feature Reporti
Page 183 and 184:
Registers M CASCADE MODE. Allows ca
Page 185 and 186:
IPI Vector/Priority Registers Offse
Page 187 and 188:
Timer Current Count Registers Offse
Page 189 and 190:
Timer Vector/Priority Registers Off
Page 191 and 192:
Registers MASK MASK. Setting this b
Page 193 and 194:
Hawk Internal Error Interrupt Vecto
Page 195 and 196:
Current Task Priority Registers Off
Page 197 and 198:
3System Memory Controller (SMC) Int
Page 199 and 200:
PowerPC Side D[0:63] DP[0:7] Correc
Page 201 and 202:
Figure 3-4. Hawk’s System Memory
Page 203 and 204:
Page Holding SDRAM Speeds Functiona
Page 205 and 206:
SDRAM Organization Functional Descr
Page 207 and 208:
Cache Coherency Functional Descript
Page 209 and 210:
Error Logging Functional Descriptio
Page 211 and 212:
Functional Description When the wid
Page 213 and 214:
Table 3-4. PPC60x to ROM/Flash (64
Page 215 and 216:
ROM/Flash Speeds ACCESS TYPE Functi
Page 217 and 218:
ACCESS TYPE Functional Description
Page 219 and 220:
I 2 C Byte Write Functional Descrip
Page 221 and 222:
I 2 C Random Read Functional Descri
Page 223 and 224:
I 2 C Current Address Read Function
Page 225 and 226:
I 2 C Page Write Functional Descrip
Page 227 and 228:
I 2 C Sequential Read Functional De
Page 229 and 230:
SDA START DEVICE ADDR M S B BEGIN R
Page 231 and 232:
Chip Configuration Programming Mode
Page 233 and 234:
FEF80070 DPE_A FEF80078 DPE_DH FEF8
Page 235 and 236:
Vendor/Device Register Address $FEF
Page 237 and 238:
SDRAM Enable and Size Register (Blo
Page 239 and 240:
SDRAM Base Address Register (Blocks
Page 241 and 242:
drr value Programming Model us (64
Page 243 and 244:
Normal View of Data (rwcb=0) Check-
Page 245 and 246:
! Caution Programming Model sien Wh
Page 247 and 248:
Programming Model esbt esbt is set
Page 249 and 250:
Scrub Address Register Programming
Page 251 and 252:
Programming Model each half of the
Page 253 and 254:
ROM B Base/Size Register Address Bi
Page 255 and 256:
ROM Speed Attributes Registers Prog
Page 257 and 258:
Data Parity Error Log Register Addr
Page 259 and 260:
Data Parity Error Lower Data Regist
Page 261 and 262:
I 2 C Status Register Programming M
Page 263 and 264:
I 2 C Receiver Data Register Addres
Page 265 and 266:
SDRAM Speed Attributes Register Pro
Page 267 and 268:
Programming Model swr_dpl swr_dpl c
Page 269 and 270:
32-Bit Counter Address $FEF80100 Bi
Page 271 and 272:
Software Considerations When the tb
Page 273 and 274:
SDRAM Size I 2 C EEPROMs Software C
Page 275 and 276:
Software Considerations c. If a CAS
Page 277 and 278:
Software Considerations Notes 1. Us
Page 279 and 280:
Software Considerations 8. Now that
Page 281 and 282:
2. For each of the Blocks A through
Page 283 and 284:
ECC Codes ECC Codes When the Hawk r
Page 285 and 286:
4Hawk Programming Details Introduct
Page 287 and 288:
8259 Interrupts PRI PSIO IRQ Input
Page 289 and 290:
Exceptions Sources of Reset Soft Re
Page 291 and 292:
Endian Issues Hawk Endian Issues Th
Page 293:
Processor/Memory Domain MPIC’s In
Page 296 and 297:
A Manufacturers’ Documents Manufa
Page 298 and 299:
A Related Specifications Related Sp
Page 300 and 301:
B MVME5100 VPD Reference Informatio
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316 and 317:
C Introduction The MVME2700 board,
Page 319 and 320:
Numerics 32-Bit Counter 3-73 SMC 3-
Page 321 and 322:
E ECC Codes Hawk 3-87 SMC 3-11 ECC
Page 323 and 324:
L L2 Cache 1-1, 1-9 L2 Cache SRAM S
Page 325 and 326:
devices, when Big-Endian 2-38 Maste
Page 327 and 328:
om_a_rv and rom_b_rv encoding 3-55
Page 329:
VME Processor Module MVME510x 1-1 V
show all

MVME5100 Single Board Computer Programmer's Reference Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?