Air Operating Permit - Puget Sound Clean Air Agency

EMISSION UNIT SPECIFIC REQUIREMENTSLB.8 Composite Processing OperationsPermit No. 13120Expiration Date: September 12, 2013Page 147 of291~~~~i6~~~~~~m~ay~u~se~~~~~q;~~~~~ ( )(II.A.2(v» ofthe subpart to calculateemission factors and to determinecompliance with the emissions limits inTables 3 (EO 8.48 through EO 8.53) to thesubpart.In lieu of the equations in Table 1(lI.A.2(v». Boeing may elect to use sitespecificorganic HAP emissions factors todemonstrate compliance provided theBoeing site specific organic HAP emissionsfactors are incorporated in the facility's airemissions permit and are based on actualfacility HAP emissions test data.g~;;mCentationon FileEO 8.35EU 8.36EO 8.3740 CFR 63.5797(4121103)40 CFR 63.5797(a)(4121103)40CFR(4121103)Boeing may also use the organic HAPemissions factors calculated using theequations in Table 1 (II.A.2(v» of thesubpart along with usage data to calculate. HAPBoeing shall use information provided bythe material manufacturer, such asmanufacturer's formulation data andMSDSs, to determine the organic HAPcontent of resins and gel coats, using theprocedures specified in paragraphs (a) (EU8.36) through (c) (EU 8.39) of 40 CFR63The organic HAP total shall include eachorganic HAP that is present at 0.1 percentby mass or more for OSHA-definedcarcinogens, as defined in 29 CFR1910.1200(d)(4), and at 1.0 percent by massHAPprovided as arange, use the upper limit ofthe range fordetermining compliance. If a separatemeasurement of the total organic HAPcontent (e.g., analysis of the material byEPA Method 311) exceeds the upper limitof the range of the total organic HAPcontent provided, then use the measuredorganic HAP content to determine!l.A.2(c)Documentationon FileNMRNMRBoeing-Everett Permit, issued September 12,2008,' Administrative Amendment 3: October 10,2012