Air Operating Permit - Puget Sound Clean Air Agency

II. MONITORING, MAINTENANCE, AND RECORDKEEPING Permit No. 13120Expiration Date: September 12, 2013Page 228 of 291If facility has followingresin type and applicationmethod ...CRIBS resins, nonatomizedmechanicalNon CRIBS resins,nonatomized mechanicalTooling resins, nonatomizedmechanicalTooling resins, manualTABLE 7 OF SUBPART WWWWThe highest weight percent HAP content, organicHAP content, or weighted avg weight % organic Is ...HAP content Boeing can use for ...CRIBS manual 48.0Non CRlHS manual 38.5Tooling manual 91.4Tooling atomized mechanical 45.9Boeing may also use a weighted average organic HAP content for each application methoddescribed in 63.581O(d)(1). Calculate the weighted average organic HAP content monthly. UseEquation 2 in 63.5810(b)(1) except substitute organic HAP content for organic HAP emissionsfactor. Boeing is in compliance if the weighted average organic HAP content based on the last12 months of resin use is less than or equal to the applicable organic HAP contents in Table 7.[40 CFR 63.5810(d)(2), 8/25/05]Boeing may simultaneously use the averaging provisions in 63.5810(b) or (c) to demonstratecompliance for any operations andlor resins not included in compliance demonstrations in63.5810(d)(1) or (2). However, any resins for which Boeing claims compliance under the optionin 63 .581O( d)(l) and (2) may not be included in any of the averaging calculations described in63.5810(b) or (c). [40 CFR 63.5810(d)(3), 8/25/05]Boeing does not have to keep records of resin use for any of the individual resins where Boeingdemonstrates compliance under the option in 63.5810(d)(1) unless Boeing elects to include thatresin in the averaging calculations described in 63.5810(d)(2). [40 CFR 63.58 I 0(d)(4), 8/25/05](aa)Reinforced Plastic Composites NESHAP Initial ComplianceTABLE 8 OF SUBPART WWWWFor ...That must meet the following organic Initial compliance will be demonstratedHAP emissions limit ...if...Open Must meet an organic HAP emissions i) Boeing meets the appropriate organicmolding limit shown in Table 3 of 40 CFR 63 HAP emissions limits for these operationsoperations Subpart WWWW (EU 8.48 through EU as calculated using 40 CFR 62.5810 (EUBoejng~Everett Permit, issued September 12, 2008,' Administrative Amendment 3: October 10, 2012