13.07.2015 Views

Air Operating Permit - Puget Sound Clean Air Agency

Air Operating Permit - Puget Sound Clean Air Agency

Air Operating Permit - Puget Sound Clean Air Agency

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

EMISSION UNIT SPECIFIC REQUIREMENTSLB.3 Coating, <strong>Clean</strong>ing, and Depainting Operations<strong>Permit</strong> No. 13120Expiration Date: September 12, 2013Page 89 of291EU 3. 209PSD-05-02,ConditionNo.12,8/25/05Access to Boeing Everett by the U.S. EnvironmentalProtection <strong>Agency</strong> (EPA), Ecology, and state or localregnlatory personnel shall be permitted upon requestfor the purpose of compliance assurance inspections.Failure to allow access is grounds for an enforcementaction under the federal <strong>Clean</strong> air Act or theWashington State <strong>Clean</strong> <strong>Air</strong> Act.NMREU 3. 210Order ofApproval No.9571ConditionNo.3(3/2/07)The exhaust ITom the spray booth shall be ventedthrough Supra II Mini-Mesh High EfficiencyOverspray Collectors by Columbus Industries.Alternatively, Boeing may use a filter system that isequivalent (or higher) in terms of particulate removalefficiency.II.A.2( d)(ii)Spray Boothsand OtherParticulateControlBoothsEU 3. 211Order ofApproval No.9571ConditionNo.4(3/2/07)Boeing shall employ high transfer efficiency coatingapplication techniques, such as high-volume lowpressure(HVLP), electrostatic, low-volume lowpressure(LVLP), hand-held aerosol cans, or air brushequipment.Il.A.I(d) WorkPracticeInspectionEU 3. 212 Order ofApproval No.9571ConditionNo.5(3/2/07)EU3.213 Order ofApproval No.9571ConditionNo.6(3/2/07)EU 3. 214 Order ofApproval No.9571ConditionNo.7(3/2/07)The spray coating area shall be inspected at least onceper week of operation for proper seating of the filters,complete coverage over the exhaust plenum, andpressure drop across the filters. Boeing shall record ifthe filters were properly seated, if the coverage of theexhaust plenum was complete, and the pressure drop.If improperly seated filters, incomplete coverage overthe exhaust plenum, or abnormal pressure drop areobserved, Boeing shall take corrective action, asspecified in the facility's Operation and MaintenancePlan.Boeing shall not spray any coatings in this booth thatare subject to the inorganic HAP requirements of theAerospace NESI-!AP (40 CFR 63.745(g)).II.A.2(d)(ii)Spray Boothsand OtherParticulateControlBoothsII.B OperationandMaintenance(O&M) PlanRequirements.Il.A.l(d) WorkPracticeInspectionBoeing-Everett <strong>Permit</strong>, issued September 12,2008,' Administrative Amendment 3: October 10, 2012

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!