ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SYSTEM UTILITY > FACTORY DEFAULT SYSTEM
Write security: 0; Read security: 0
Resets the entire system to the factory default settings. To reset the system, press Y. To cancel this
command, press N. When you select this command, the following message displays:
MODULES
This will delete all configuration settings. ADTRAN recommends making a backup
copy of the configuration before defaulting the system.
Write security: 3; Read security: 5
The MODULES menu provides status information and menu options that allow you to configure and control
the installed option modules as well as the network ports (see Figure 8).
Figure 8. Modules Menu
If you install a module in a slot, then want to install a different type of module in the slot,
you must set this field to EMPTY before selecting another module type.
If a module is installed, the module type automatically shows the name of the installed
module, and it cannot be set to any other option.
61200305L2-1B © 2004 ADTRAN, Inc. 101