ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM CONFIG > ACCESS PASSWORDS > ACTIVE
Read security: 0
Displays the number of users currently logged into the system (listed for each configured LABEL).
SYSTEM CONFIG > LICENSES
Write security: 0; Read security: 0
(Not currently used.) Provides menus to enable the optional ATLAS 550 feature upgrades.
FEATURE Names the ATLAS 550 feature upgrade.
LICENSE KEY Displays the license key of the feature upgrade.
SERIAL NUMBER Displays the serial number of the feature upgrade.
LIC CNT Displays the number of instances of the feature that the license provides. This
field may not be applicable for a given feature -- if it is not, this field is blank.
STATUS Reflects the status, PERMANENT or TEMPORARY, of the feature upgrade license
key.
SYSTEM CONFIG > BONDING CONFIG
Write security: 3; Read security: 5
Displays the configuration submenus available for the BONDing Module. This configuration is shared
among all BONDing Modules.
SYSTEM CONFIG > BONDING CONFIG > TXINIT TIMER
Write security: 3; Read security: 5
Specifies the length of time the originating endpoint attempts to detect the BONDING negotiation pattern
from the answering endpoint before deciding the BONDING call has failed.
SYSTEM CONFIG > BONDING CONFIG > TXFA TIMER
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to detect the BONDING frame pattern when a call is
connected before deciding the BONDING call has failed. When interoperating with other manufacturers'
BONDING equipment, it may be necessary to change this time so that it matches TXADD01.
SYSTEM CONFIG > BONDING CONFIG > TXADD01 TIMER
Write security: 3; Read security: 5
Specifies the length of time both endpoints wait for additional calls to be connected at the end of
negotiation before deciding that the BONDING call has failed. The factory default setting is sufficient for
most calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow
for slower call routing.
SYSTEM CONFIG > BONDING CONFIG > TXDEQ TIMER
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to equalize the network delay between the bearer
channels (B channels) before deciding the BONDING call has failed.
90 © 2004 ADTRAN, Inc. 61200305L2-1B