ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SYSTEM UTILITY > PING > ROUND TRIP MAX
Read security: 5
Displays the maximum round trip time of the ping request/reply of the current set of pings.
SYSTEM UTILITY > PING > TX STATS
Read security: 5
Displays the number of ping requests transmitted (n TXED), the number of ping replies received (n RXED),
and the number of ping requests that were lost (n LOST).
SYSTEM UTILITY > PING > RESET STATS
Write security: 5; Read security: 5
Resets all ping statistics to zero. If the ping client is active, this menu will stop it.
SYSTEM UTILITY > PING > START/STOP
Write security: 5; Read security: 5
If the ping client is currently idle, this menu sends pings to the specified address. If the ping client is active,
the menu either starts or stops sending pings.
SYSTEM UTILITY > ATEL CLIENT
Write security: 5; Read security: 5
Allows a user to remotely configure ADTRAN TSUs using ADLP over the inband management channel
on a V.35 port. This feature only allows for remote sessions through the ATLAS 550 to the TSUs – not vice
versa.
SYSTEM UTILITY > ATEL CLIENT > ATEL ADDRESS
Write security: 5; Read security: 5
Defines the ADLP address (Unit ID) assigned to the remote unit you are trying to connect to. The valid
range is 2 to 65520.
SYSTEM UTILITY > ATEL CLIENT > CONNECT
Write security: 5; Read security: 5
Activator used to start an ATEL client session to the remote unit configured in the ATEL ADDRESS field.
SYSTEM UTILITY > TELNET CLIENT
Write security: 5; Read security: 5
Allows a user to open a Telnet session to any device listed in the ATLAS 550 route table.
SYSTEM UTILITY > TELNET CLIENT > ADDRESS
Write security: 5; Read security: 5
Defines the IP address assigned to the remote unit you are trying to connect to.
61200305L2-1B © 2004 ADTRAN, Inc. 99