ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 3 Network Turnup Procedure
Wallmount Installation (Continued)
Step Action
5. Have someone else hold the unit in position as you install four #6 to #10 (1 1/2” or
greater in length) wood screws through the unit’s brackets and into the mounted
board.
6. Proceed to the steps given in Supplying Power to the Unit on page 56.
Step 1: Attach both wall mount
brackets (supplied in shipment) to
chassis using four #6-32 (5/16" in
length) screws (supplied in shipment).
Step 3: Prepare the
mounting surface by
attaching a board
(typically plywood, 3/4"
to 1" thick) to the wall.
(The board must be
attached to a stud in
the wall for stability.)
Step 2: Remove screws (using a
Phillips-head screwdriver) and
disconnect all four rubber feet on
the bottom of the chassis.
Figure 1. Wallmounting the ATLAS 550
Step 4: Wall mount the ATLAS 550
chassis using four #6 to #10 (1 1/2"
or greater in length) wood screws.
61200305L2-1B © 2004 ADTRAN, Inc. 55