ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DIAL PLAN (E1/PRA) > USER TERM (PRA) > IFCE CONFIG (PRA) > SWAP ANI/DNIS
Write security: 3; Read security: 5
Swaps the ANI and DNIS numbers received from the network. ANI (Automatic Number Identification) is
the billing number of the calling party, and DNIS (Dialed Number Identification Service) is the called
party number.
With this swap, the ATLAS 550 switchboard uses ANI to route the call. The accept number
in the dial plan must use the ANI number, not the DNIS number.
DIAL PLAN (E1/PRA) > USER TERM (PRA) > IFCE CONFIG (PRA) > B CHANNEL SELECTION
Write security: 3; Read security: 5
Determines how the ATLAS 550 switchboard uses B channels for call routing. The Circular method can be
used for call load balancing among the available B channels on this interface.
NORMAL Always start with the last channel configured (i.e., for a full PRI channel 23
would be used if available).
CIRCULAR Contiguous channels from last to first.
DIAL PLAN (BRI DBU NETWORK INTERFACE AND QUAD BRI/U MODULES)
All menu items in this section (listed as U-BRI) apply to BRI DBU Network and Quad BRI/U Module
interfaces configured in the DIAL PLAN.
DIAL PLAN (U-BRI) > NETWORK TERM
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which terminate a BRI connection from the
network.
DIAL PLAN (U-BRI) > NETWORK TERM > IFCE CONFIG
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
DIAL PLAN (U-BRI) > NETWORK TERM > IFCE CONFIG > SWITCH TYPE
Write security: 3; Read security: 5
Defines the type of BRI switch to which the port is connected. If connected to another ATLAS 550, both
need to be set to the same switch type. The following options are available:
• Lucent 5E • Northern DMS 100 • National ISDN
278 © 2004 ADTRAN, Inc. 61200305L2-1B