ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 7, CFG-1
5. Enter the correct call routing information for this PRI by selecting the OUT#ACCEPT field and pressing
. Then press the right-arrow key to enter the right-pane menus. Select the ACCEPT NUMBER
field and press . To allow ALL calls to route out this PRI to the network, enter a “$.”
For a detailed explanation of possible entries, highlight the ACCEPT NUMBER field and
press .
6. Configure the parameters needed for proper operation of the PRI D channel by selecting the IFCE
CONFIG field and pressing . Once at the IFCE CONFIG menus, configure the switch type by
selecting the SWITCH TYPE field and choosing the appropriate protocol. (Remember, this is the protocol
running on the Central Office switch, not the manufacturer’s name.) For this sample network, choose
the NATIONAL ISDN selection.
The remaining configuration parameters are normally left at default values. For more
details on these parameters, please refer to your ATLAS 550 System Manual.
61200305L2-1B © 2004 ADTRAN, Inc. 359