ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
DIAL PLAN > NETWORK TERM > SIG
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (endpoint). Select RBS for a T1 using Robbed
Bit Signaling or PRI for a Primary Rate ISDN interface. Select NFAS for a non-facility associated
signalling interface or NONE for OSC when bonding DS0s. This selection is only necessary if a T1/PRI is
selected as the SLOT/PORT type.
One HDLC resource is used by each PRI or each Packet Endpoint.
DIAL PLAN > NETWORK TERM > OUT#ACCEPT
Write security: 3; Read security: 5
Defines the parameters for the outgoing calls that ATLAS 550 sends to the network.
DIAL PLAN > NETWORK TERM > OUT#ACCEPT > SRC ID
Write security: 3; Read security: 5
Identifies the call source ID from which this endpoint accepts calls. This field simplifies the creation of a
dial plan in applications where the criterion for switching calls to a certain endpoint is a function of which
endpoint originated the call. SRC ID may be entered with the usual wild card entries (except $).
X = Any digit 0 through 9
[1,3,5] = Any of these digits
0 = Default value
The default ID for all source endpoints all accept numbers is 0. This results in all calls being routed based
on the dialed number.
DIAL PLAN > NETWORK TERM > OUT#ACCEPT > ACCEPT NUMBER
Write security: 3; Read security: 5
Designates which numbers this endpoint passes on toward the network. The accept list may consist of
multiple entries. The numbers are defined using the following “wild cards”:
X = Any single digit
N = Any single digit 2 through 9
$ = Any number of digits of any value
9 = This specific number
[1,2,3...] = A single digit in this group
Example: 1-800-$ only permits toll-free, long distance calls to 1-800. If this were used, then a second
accept number would need to be specified (NXX-XXXX) permitting local numbers to be dialed.
Any specific entry takes precedence over a wild card. For example, if endpoint A was
designated as $ while endpoint B accepted 963-800X, then an incoming call to 963-800X
would only be accepted by endpoint B.
61200305L2-1B © 2004 ADTRAN, Inc. 251