ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM UTILITY
Use the SYSTEM UTILITY menu to view and set the system parameters shown in Figure 6.
SYSTEM UTILITY > UPDATE FIRMWARE
Figure 6. System Utility Menu
Write security: 1; Read security: 5
Updates firmware when ATLAS 550 enhancements are released. Two transfer methods are available for use in
updating any modules that contain Flash memory—including the ATLAS 550 system controller. The first
transfer method uses the ATLAS 550 serial CRAFT or ADMIN port of the system controller and XMODEM
protocol. The second transfer method uses the ATLAS 550 built-in ETHERNET port of the system controller
and Trivial File Transfer Protocol (TFTP). For more details on updating firmware, please refer to DLP-6 and
DLP-7.
SYSTEM UTILITY > UPDATE FIRMWARE > MODULE SLOT
Write security: 1; Read security: 5
Displays the slot you selected for firmware updating. When this option first appears, NONE SELECTED
displays. When you move the cursor to this field and press , a dialog box opens, allowing you to
select SLOT 0 (ATLAS 550 system controller), NTWK 1 or 2 (if an upgradable network module is installed),
SLOT 1 through SLOT 4 (if an upgradable module is installed), RSRC 1 through 4 (if an upgradable resource
module is installed), or ALL MODULES OF A TYPE.
SYSTEM UTILITY > UPDATE FIRMWARE > MODULE TYPE
Write security: 1; Read security: 5
Reflects the module type selected in MODULE SLOT. The selections only include upgradable modules.
92 © 2004 ADTRAN, Inc. 61200305L2-1B