ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
CTS OPTION
Write security: 3; Read security: 5
Configures the Clear To Send (CTS) signal on this interface. CTS may be forced on or can be
configured to be asserted only when Request To Send (RTS) is asserted.
DATA FORMAT
Write security: 3; Read security: 5
Configures the data format scheme used on this SLDC endpoint for either NRZ (Non-Return to
Zero) or NRZI (Non-Return to Zero Inverted). Using NRZ configures the Legacy Data Module to
encode using ones and zeroes represented by opposite and alternating high and low voltages. There is
no return to a zero reference voltage between encoded bits. Using NRZI configures the Legacy Data
Module to encode ones with a voltage change and zeroes with no voltage change. NRZI encoding is
also known as transition coding
PACKET MANAGER > PACKET ENDPNTS > CONFIG > SUBLINKS - FRAME RELAY
Write security: 3; Read security: 5
Contains the configuration parameters for individual sublinks, or PVCs. The following parameters are
available.
NAME
Write security: 3; Read security: 5
User-definable name for the DLCI.
DLCI
Write security: 3; Read security: 5
Local address for each PVC as assigned by the carrier.
QOS
Write security: 3; Read security: 5
Quality of service. These values can be used to assign a guaranteed amount of bandwidth available
for this connection. The sum of all QOS values for the sublink should not exceed the Committed
Information Rate (CIR).
BURST
Write security: 3; Read security: 5
Sets the burst rate used by this virtual circuit for data traffic. A value of zero means that the burst rate
is not limited. The value is in kilobits/second. If voice traffic is flowing on ANY sublink on the port
carrying THIS sublink, you should enter a value for this setting. Otherwise, leave this field set to
default (zero). If the service provider has supplied a 'Be' value, enter that value in this field. The burst
rate defines the amount that this virtual circuit is allowed to exceed the CIR. If the service provider
has not supplied an excess burst rate, enter the wire speed in this field.
61200305L2-1B © 2004 ADTRAN, Inc. 199