ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
MODULES (E&M-8) > STATUS > PRT
Read security: 5
Displays the operating port number. There are eight available ports on the Octal E&M Option Module
MODULES (E&M-8) > STATUS > STATUS
Read security: 5
Displays the call status of each voice port. This field displays one of the following messages:
INACTIVE The port is pre-configured, but the E&M module is not present.
DISABLED The E&M module is present, but the port is not mapped.
UNKNOWN Information about the port is not available.
IDLE The selected trunk is configured but currently not in use.
E-LEAD ASSERTED The E-Lead is asserted, indicating a far-end seizure.
M-LEAD ASSERTED An M-Lead current has been detected, indicating a near-end seizure.
TO The port is configured for Transmission Only mode.
CALL IN PROGRESS Indicates there is a current, active call on the selected E&M port.
TEST E-LEAD OPEN Forces an on-hook situation for testing purposes.
TEST E-LEAD CLOSED Forces an off-hook situation for testing purposes.
TEST Generic test indicator.
TEST-UNKNOWN The port is in test mode, but additional information about the active test
is not available.
MODULES (E&M-8) > STATUS > RX ABCD
Read security: 5
Receive Signaling bits have local significance only, and represent signaling between the ATLAS 550
Controller and the voice port if the port is configured in the DIAL PLAN. The bit pattern is formatted ESF
RBS.
MODULES (E&M-8) > STATUS > TX ABCD
Read security: 5
Transmit Signaling bits have local significance only, and represent signaling between the ATLAS 550
Controller and the voice port if the port is configured in the DIAL PLAN. The bit pattern is formatted ESF
RBS.
MODULES (E&M-8) > TEST
Write security: 4; Read security: 5
These options initiate different types of tests and display test results.
MODULES (E&M-8) > TEST > PORT
Write security: 5; Read security: 5
Displays the operating port.
61200305L2-1B © 2004 ADTRAN, Inc. 157