ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DNIS DELAY
Write security: 3; Read security: 5
(Available only when E&M CONVERSION is enabled.) Defines the time we delay after transmitting a
wink in response to the 2W going off hook (after ringing) before we send off hook in the RBS
signaling. This field is only valid for E&M conversion. The timing is as follows:
The following submenu item becomes visible when DNIS DELAY is activated:
DNIS WINK TIMEOUT
Write security: 3; Read security: 5
When DNIS DELAY is ENABLED, a wink will be returned to the originating switch after 5 seconds
if the FXS does not detect an off hook. This option, when DISABLED, allows the FXS port to ring
without winking until the call is answered.
DEDICATED MAPS (QUAD/OCTAL FXO MODULE)
DEDICATED MAPS (FXO) > CREATE/EDIT MAPS > CONNECTS
Write security: 3; Read security: 5
Enters the dedicated map connections. Press to activate the submenus.
DEDICATED MAPS (FXO) > CREATE/EDIT MAPS > CONNECTS > TO/FROM CONFIG
Write security: 3; Read security: 5
Specifies the configuration for the TO/FROM connection. The following selections may apply to the
Quad/Octal FXO Option Module, depending on the application:
# PORTS
Rx AB
Tx AB W
DNIS Delay
Trunks can be taken out of service by telco if there is No wink. Use caution when disabling
this option.
Write security: 3; Read security: 5
Defines ports to be used for this connection.
Off Hook
238 © 2004 ADTRAN, Inc. 61200305L2-1B