ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SYSTEM CONFIG > BONDING CONFIG > TANULL TIMER
Write security: 3; Read security: 5
Specifies the length of time the answering endpoint attempts to detect the BONDING negotiation pattern
from the originating endpoint before deciding the BONDING call has failed. It may be necessary to
shorten this timer if the DTE equipment using the BONDING module also has timer constraints for
completing non-BONDING parameter negotiation.
SYSTEM CONFIG > BONDING CONFIG > TCID TIMER
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to negotiate an agreeable value for bearer channels (B
channels) and channel capacities before deciding the BONDING call has failed.
SYSTEM CONFIG > BONDING CONFIG > CALL STAGGER
Write security: 3; Read security: 5
Specifies the amount of delay between placing calls for outgoing BONDING sessions. The following call
stagger values are available: NO STAGGER, 500 MS, 1 SEC, and 2 SEC
SYSTEM CONFIG > ALARM RELAY RESET
Write security: 3; Read security: 5
Clears the Alarm Relay located on the back panel of the ATLAS 550. Activating the software Alarm Relay
Reset functions the same as manually pressing the ACO switch located on the ATLAS 550 front panel.
SYSTEM CONFIG > ALARM RELAY THRESHOLD
Write security: 3; Read security: 5
Defines which threshold sets the Alarm Relay. These thresholds include CRITICAL, MAJOR, MINOR,
WARNING, and NORMAL. If an alarm occurs that is greater than or equal to the threshold selected, the Alarm
Relay will set. For example, if the threshold is set for MAJOR, then ALL MAJOR alarms and ALL CRITICAL
alarms will set the Alarm Relay. There is one exception – setting the threshold to NORMAL will not set the
Alarm Relay for NORMAL events. No NORMAL events set the Alarm Relay.
61200305L2-1B © 2004 ADTRAN, Inc. 91