ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
ROUTER > IP > ROUTES > USED
Read security: 2
Displays the number of times the router has referenced this route.
ROUTER > IP > ROUTES > CLR
Write security: 2; Read security: 2
Clears the USED menu and resets the value to zero.
ROUTER > IP > ROUTES > FLAGS
Read security: 2
Indicates the properties of this routing table entry, composed of the following letters:
H – route is a host route
G – route is a gateway route
DR – route learned dynamically from RIP
I – route learned from an ICMP redirect
A – route learned from IARP
P – route is private and is not advertised with RIP
T – route is to a triggered port (updated only when table changes)
ROUTER > IP > ROUTES > HOPS
Read security: 2
Displays the number of router hops required to get to the network or host. Ranges from 0 to 16. If set to 16,
the route is defined as infinite and cannot be used.
ROUTER > IP > ROUTES > COST
Read security: 2
Displays the total cost of sending a packet to the specified network. Normally, the cost is based on the
available bandwidth.
ROUTER > IP > ROUTES > TTL
Read security: 2
Displays the number of seconds until the address is removed from table. A value of 999 means the route is
static.
ROUTER > IP > INTERFACES
Write security: 2; Read security: 2
The INTERFACES menu configures and monitors all interfaces connected to the ATLAS router. These
include the Ethernet and frame relay DLCIs connected in the PACKET MANAGER/ PACKET CNCTS.
61200305L2-1B © 2004 ADTRAN, Inc. 219